Floor Plenum acts different for same downflow crac

[DCIM_Support]

This question was originally posted on DCIM Support by Erhan Yasar on 2018-09-04

---

Hello community,

Our customer wants to know why the floor plenum gives different results for same downflow cracs. In screenshot, you can see the top side of the airflow is red and bottom side is yellow. All cracs has the same values in their configuration.

Thanks in advance,

(CID:134026124)

[DCIM_Support]

This answer was originally posted on DCIM Support by Jef Faridi on 2018-09-04

---

Hi Erhan,

Airflow may also depend on the location of equipment in the setup. Equipment (and there location) located at top are not the same as equipment located at bottom, so the airflow in those regions may not be the same (even though there could be identical CRAC's).

Kind regards

(CID:134026150)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.