Hello again, This Telepace Ladders to RemoteConnect conversion app is going into testing very soon and we expect it to be ready for prime time sometime in the third quarter of this year. So please stay tuned.   Also note however, that no control logic conversion application can guarantee a 100% conversion. Some work will still need to be done within RemoteConnect to validate the final operation.   Regards, Martin ... View more

Hello all, An audio error has been detected in Remote Connect DNP3 Basics Part 2: Data Classes and Events. We have taken the video down temporarily until such time as the error is corrected. This should be done within the next week. We apologize for the inconvenience and also thank the eagle-eyed (eared?) viewer who caught the error. Thank you. Martin Chartrand ... View more

Hello all, Just an additional note about these videos. Although the SCADAPack 47x Smart RTU is referenced in these videos, the product is not released yet. We're looking at a 3rd-quarter 2020 release date at this time. However, any DNP3 functionality demonstrated here in RemoteConnect can be applied to the SCADAPack 57x Smart RTUs, which is currently available. Regards, Martin Chartrand ... View more

Hello, I found this in the Realflo User Manual: Navigation: Communication Protocol Reference > TeleBUS Protocol Interface > TeleBUS Configuration Registers > Orifice Plate Change     "Changing the orifice plate requires forcing inputs and changing the AGA‑3 configuration. Use the following commands to force the inputs before making a change to the AGA‑3 configuration. Refer to AGA-3 Configuration for commands to change the orifice plate."   So yes, in theory, you could use a digital input (internal or external) to change the orifice plate diameter but you would need to program separate logic in the RTU to handle all of the commands in their proper sequence to do so based on the state of the digital input. It's not a simple matter of simply writing a new value to an internal Modbus register.   You would need to start here and then go through the sequence: Navigation: Communication Protocol Reference > TeleBUS Protocol Interface > TeleBUS Configuration Registers > AGA-3 Configuration     I hope this helped. M ... View more