Follow along for an enriching discussion with our CEO, Peter Herweck, and industry leaders for a captivating Global Keynote at #InnovationSummit Paris 2024. Watch recording and join the #ImpactMaker movement!️
running a 400V ups with 220v?
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-02-0508:22 AM
Not sure I understand what you’re saying so will ask. Are you saying the unit in question is currently operating fine and connected to 220 3 Phase? If so it would be the model that supports the 3 different voltages as listed on page 26 of the install guide.
It would probably make sense to lay eyes on the unit and see the name plate indicating the operating voltage(s). If 220 is listed and the previous owner had it operating fine this could be a good deal.
If however the name plate DOES NOT indicate 220 VAC as one of the operating voltages. Your company is playing with fire never mind loss of insurance coverage.
Take some photos of the unit, name plate, serial number and ask APC directly as to this unit’s suitability. Asking more questions never killed anyone never mind getting them fired! 🤣🤦♂️☝️