APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:44 AM . Last Modified: 2024-03-14 12:32 AM
Hi y'all.
I have been looking through the forums for information on the config.ini file and particularly what the Event Action Config section does. I think that I understand it (please see attached MS Word document) with the exception of the =E and =ES immediately after the event action id. E seems to mean write to the event log, but I would like to know what =ES does. Some of the events that have been configured on a test UPS/NMC keep =ES throughout, some change to =E. The best guess I can make is that it is some identifier for a system event.
Can anybody shed any further information?
Many thanks
Peter
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:44 AM . Last Modified: 2024-03-13 11:48 PM
no problem, glad it helped.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:44 AM . Last Modified: 2024-03-14 12:32 AM
Hi and thanks very much for the reply, just what I was after!
Just to put your mind at rest, I wasn't intending to configure events through the config.ini file but use the information to document what will become the standard configuration for some 15 UPS units in different offices. I had already drawn the conclusion that it was best to configure one and then upload the config file to each UPS.
Once again, thanks for the info.
Peter
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:44 AM . Last Modified: 2024-03-13 11:48 PM
Hi y'all.
I have been looking through the forums for information on the config.ini file and particularly what the Event Action Config section does. I think that I understand it (please see attached MS Word document) with the exception of the =E and =ES immediately after the event action id. E seems to mean write to the event log, but I would like to know what =ES does. Some of the events that have been configured on a test UPS/NMC keep =ES throughout, some change to =E. The best guess I can make is that it is some identifier for a system event.
Can anybody shed any further information?
Many thanks
Peter
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:44 AM . Last Modified: 2024-03-13 11:48 PM
no problem, glad it helped.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.