APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-28 06:40 AM . Last Modified: 2024-03-18 01:11 AM
I've recently acquired a used AP5610. However, the power LED (rear) is flashing, which apparently means the KVM is in boot mode. According to the manual it might be rescued by tftp. I looked for the default firmware on the APC website, but it doesn't seem to be there. Does anyone know from where it might be downloaded?
Thanks!
Message was edited by: amendpa
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-28 06:40 AM . Last Modified: 2024-03-18 01:11 AM
Thanks very much!
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-28 06:40 AM . Last Modified: 2024-03-18 01:11 AM
Thanks very much!
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.