Schneider Device Manager issue in discovering AS-Ps

[Jim_Okapal]

Good news:

When performing a discover on my network, it found my office AS-P

and every MNB device for IA-Series, b3 on the AS-P, and all Andover

b3 devices under the bCX

Bad news:

It found my AS-P twice and put an orange highlight for both.  Upon 

investigation, i found that if i disable the 2nd ethernet port on the 

AS-P, then everything clears up if i purge all entries in the Bacnet

Comm/network/router table and re-discover.  

My 2nd AS-P port is set up as a dual Ip network with DHCP, just like

we'd want for bringing in MPX devices on a private network.  The 

2nd IP port also has its own unique bacnet network number.  I even

changed it to make sure it is unique and purged the entries again

in the jace bacnet network and rediscovered.  No difference.

It plainly doesn't like seeing the 2nd AS-P ethernet port being activated

as it's own bacnet network.   Issue or no issue?

[Jim_Okapal]

Jace Port #1 is attached to the office ethernet (BACnet network 100)

Jace Port #2 is used for MPX controllers (Bacnet network 71)

AS-P Port #1 is attached to the office ethernet (Bacnet network 100)

AS-P Port #2 is DHCP server 10.110.210.1 (BACnet network 200)

AS-P is being seen twice from Jace when Ethernet Port #2 is active

on the AS-P