Schedule blocks default priority writing of 16

[Jim_Okapal]

When bringing in a schedule block, i noticed that the selection for the

"Priority For Writing" is grayed out at 16.  I believe this is similar to EBO

workstation where it will use the default priority that you picked in the

control panel for the entire station.   I assume this is the case here.

Does changing the default priority of the Jace8000, allow the schedule to 

write to priority 10 if required?   I haven't immediately found this setting

but i know i've had to do something similar in the past for other jobs in AX. 

[Will_Workman]

@Jim_Okapal the MPX Firmware does not support changing this setting so it is greyed out to prevent the user from trying.

I am not away of an equivalent settings in Niagara.  The Niagara station will write to priority 16 for normal operation, priority 8 for overrides, and priority 2 for emergency overrides.  If you use the set command it will write to the relinquish default.

[Julio_Cortes]

@Jim_Okapal I think this should be raised as a design concern since an engineer may want an external write to be PFW 16 and local logic at a different PFW like 15.