Default block placement on Wire Sheet for Schneider objects

[Jim_Okapal]

When placing blocks on the wiresheet, i tend to drag the objects to the location on the

wiresheet where i need them.  In the case of the Config blocks, it will momentarily put them

in the spot you choose, but will then move them to the upper left corner after the driver

sets the new instance number of the object.  

Was wondering if the mouse location could be kept in memory and place the edited 

block back into the same location, or else just change the instance number in the

same block location with no actual movement.  

[Will_Workman]

That sounds like a defect to me.  We will need to report that to Tridium to get that fixed.

[RandyDavis]

We did notice this and considered it an annoyance but it really should be corrected.  If you do an "upload all" you will also notice some odd positioning of objects.  This will need to be addressed as well.