I am new to the Scada pack RTU. I have seen couple of videos to get started with 334E RTU. But I have encountered error Below are the images:
What is the problem and what should I do?
Do you have a valid configuration in the RTU?
Configuration Corrupt would make complete sense if it was 'empty' i.e. unconfigured. Or if you downloaded a configuration into it that was indeed corrupt (i.e. not valid).
The Function Code not implemented I'd probably just ignore until you get rid of the Configuration Corrupt.
Bevan's reply may have contained enough information to lead you to a solution. If not, however, please feel free to contact our Technical Support team. When you do, make sure you give them as much information as possible. Eg:
- RTU model
- Firmware in the RTU
- Any logic or E Configurator configuration already in the RTU
- Logic or config file you were attempting to load into the RTU
- And the same error screen capture you posted here
You can contact our Tech Support team using either of these two methods:
Discuss challenges in energy and automation with 30,000+ experts and peers.
Find answers in 10,000+ support articles to help solve your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!