rated diversity factor of whole assembly

Invite a Co-worker

Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

How can we help?

rated diversity factor of whole assembly

Back to Power Standards & Regulations

410

The IEC 61439 part 0 talks about specifying rated diversity factor ( suiting a particular application) for the whole assembly or for group of circuits .

It also defines rated diversity factor for a whole assembly as the average loading conditions for which the assembly is designed . If the rated diversity factor of the assembly is say 0.8 then it means any combination of outgoing circuits can be loaded to 80% of their rated current , provided the total load on the o/g circuits do not exceed rated current of the assembly.

My question is how to specify the RDF in a tender specification ? What is the rated diversity factor of BLOKSET and PRISMA LV switchboards ? Can i use this as a differentiating factor and winning spec for Blokset and Prisma