Posted: 2021-08-12 07:13 AM
The documentation says that the modules are identified by their position in the island which is therefore used to generate an "ID" + position.
I have the configuration below
When it is integrated via the DTM in unity pro, I recover from the following equipment DDT where it can be seen that the "IDs" do not correspond at all to the position of the module.
I don't understand why ?
I use Unity pro V12 and advantys
Posted: 2021-10-21 09:04 AM
Did you remove modules from the initial configuration or have you made any changes to the configuration? if you do that then the IDx will not line up. if you create a USER Defined label within Advantys rather than allowing Unity to create the variable for you then the Variable will always line up with the slot you are using.
Discuss challenges in energy and automation with 30,000+ experts and peers.
Find answers in 10,000+ support articles to help solve your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!