EcoStruxure Power Design Forum
Schneider Electric support forum to share knowledge about installation and usage for Electrical Network Design and Calculation Software (Ecodial, Ecostruxure Power Design).
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-10-30 12:35 AM . Last Modified: 2021-11-10 09:16 AM
Hi,
I've just downloaded and installed new INT 4.9.7 & FR 4.9.4 releases of Ecostruxure Power Design and the MTZ breaker thermal setting facility is not updated yet.
Indeed, with actual micrologic tripping units, thermal settings are adjustable amp by amp like NSX MCCB (5.2 or 5.3).
Currently, in Power Design, only fixed values are available replicated from old NT/NW trip units.
Could you update quickly the soft to take account the good set facility with a patch or a sub release ?
Thank you in advance
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-11-10 11:18 PM
Hello,
Thanks for this inputs.
This fine settings of the latest trip units are already informed as a requirement.
This is listed as part of product backlog, and also the implementaion feasibility is under analysis now.
Based on the conclusion of the analysis this will be considered for implementation.
Regards,
Ecodial Expert Support.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.