EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:15 AM
This question was originally posted on DCIM Support by Sergio on 2017-11-22
Hi,
there seems to be a problem with the value of several sensors, we are using modbus DDF CCLAN Module versión 5,
It is posible to check this:
Thanks in advance
Regards
(CID:126179564)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:16 AM
This answer was originally posted on DCIM Support by mike sutton on 2017-11-23
Hi Sergio,
What controller is fitted to the generator? I monitor Himoinsa gen sets but I tend to Poll the controller using the modbus DDF for a generic controller as below
Hope this helps!
Mike
(CID:126179808)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:15 AM
This answer was originally posted on DCIM Support by spezialist on 2017-11-22
Dear Sergio,
Judging from the screenshot below, this type of generator sets have successfully supported by DCE software:
Therefore, you can draw two conclusions: either you use an incorrect or not actual DDF-file (I do not think so 😀. Or, you need to create another Request modification for your DDF-file, so that DDF-team fixes the errors you found.
I am also personally interested in this, because soon, I will also need to connect a generator set of the same type to the infrastructure monitoring system with DCE-servers.
With respect.
(CID:126179613)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:15 AM
This comment was originally posted on DCIM Support by Sergio on 2017-11-27
Hi, Thanks Spezialist and Mike
I going to request the DDF modification
regards
(CID:126181205)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:16 AM
This comment was originally posted on DCIM Support by spezialist on 2017-11-27
Dear Sergio,
Thank you for following my advice 😀.
(CID:126181212)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:16 AM
This answer was originally posted on DCIM Support by mike sutton on 2017-11-23
Hi Sergio,
What controller is fitted to the generator? I monitor Himoinsa gen sets but I tend to Poll the controller using the modbus DDF for a generic controller as below
Hope this helps!
Mike
(CID:126179808)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:16 AM . Last Modified: 2023-10-22 11:08 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.