netbotz room monitor 355a error

[DCIM_Support]

This question was originally posted on DCIM Support by jawakharlal on 2019-10-09

---

when i set up netbotz 355a from console, the device generated an error when saved data.

now i see in console this text in an endless loop:

U-Boot 1.1.4 (Jun 20 2017 - 14:16:41) MPC8248 Reset Status: Check Stop, External Soft, External Hard MPC8248 Clock Configuration - Bus-to-Core Mult 3x, VCO Div 4, 60x Bus Freq 16-50 , Core Freq 50-150 - dfbrg 0, corecnf 0x10, busdf 3, cpmdf 1, plldf 0, pllmf 3 - vco_out 400000000, scc_clk 100000000, brg_clk 100000000 - cpu_clk 300000000, cpm_clk 200000000, bus_clk 100000000 - pci_clk 33333333 CPU: MPC8248 (HiP7 Rev 14, Mask 1.0 1K50M) at 300 MHz Watchdog enabled I2C: ready DRAM: 128 MB

(CID:149783717)

[DCIM_Support]

This comment was originally posted on DCIM Support by spezialist on 2019-11-03

---

Dear jawakharlal,

Please tell us, were you able to solve your problem or not?

With respect.

(CID:151062353)

[DCIM_Support]

This comment was originally posted on DCIM Support by jawakharlal on 2019-11-07

---

yes, we returned the goods to the supplier

(CID:151063592)

[DCIM_Support]

This comment was originally posted on DCIM Support by spezialist on 2019-11-07

---

Ok, very thanks for the good feedback :-). 

(CID:151063772)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.