cold aisle

[DCIM_Support]

This question was originally posted on DCIM Support by MANCINO Rocchino on 2019-03-14

---

Hello

I need to create a cold aisle for only one raw of racks.The Cold Aisle genome is for 2 raw....

How can I do this?

Best regards

Rocchino

(CID:140714085)

[DCIM_Support]

This answer was originally posted on DCIM Support by Ed Tarento on 2019-03-14

---

Hi Rocciho

r u trying to create a cold aisle containment system or a cold aisle?   If the latter use the genome for an aisle and rotate it so the think bar of the aisle front matches your setup

Cheers

(CID:140714317)

[DCIM_Support]

This comment was originally posted on DCIM Support by MANCINO Rocchino on 2019-03-15

---

Hello

Tks for your answer. It's a Cold aisle containement for one raw of racks.

It's already done for 3 Cold Aisle Containement..😀

best regards

Rocchino

(CID:141268265)

[DCIM_Support]

This comment was originally posted on DCIM Support by MANCINO Rocchino on 2019-03-15

---

Hello again

Found!

1. Create racks
2. Put racks in raw (do not use existing )
3. Slip on the raw the Cold Aisle Containement System genome
4. Adjust the CAC

Rocchino

(CID:141268267)

[DCIM_Support]

This comment was originally posted on DCIM Support by MANCINO Rocchino on 2019-03-26

---

Hello

found 😀

Solution very simple.

1 you put the racks in one raw

2 apply the Cold Aisle genome

DCO create automaticaly the good one 😀

(CID:141268270)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.