This question was originally posted on DCIM Support by Benjamin on 2019-05-16
I have a shelf in my rack that permanently extends outward from the front rack. How to I account for this, spatially, on my rack in my electrical room?
I also need to make it 2u, and the shelf in the master Genome is 1u and there is no way to change that under "Properties."
(CID:143758943)
This answer was originally posted on DCIM Support by Greg Sterling on 2019-05-16
I do not think its possible to have an asset extend through the front. When I extend assets beyond the rack depth it appears they extend through the rear side of the rack.
I have not found a way to extend a device through the front.
I doubt you'd want to place the racks backwards in this case.
Regards
Greg Sterling
(CID:143760242)
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Discuss challenges in energy and automation with 30,000+ experts and peers.
Find answers in 10,000+ support articles to help solve your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!