This question was originally posted on DCIM Support by Kevin Kolobe on 2020-01-31
I have a Netbotz 750 running firmware 5.2.0. I have 2 x leak ropes and 6 x dry contacts on board with 5 x sensor pods on the A-link bus.
All my sensors are showing disconnected although all sensor pods are on and recording. Any suggestions what the issue could be?
Note that i have a power supply on the one of the sensor pods and have added an additional power supply for testing which has not help one bit.
This comment was originally posted on DCIM Support by GavOB on 2020-01-31
Hi Kevin Kolobe,
Had they been working or is this a new install?
What model are the sensor pods, do you have any sensors connected directly and if so are they showing up as disconnected too?
This comment was originally posted on DCIM Support by Kevin Kolobe on 2020-01-31
The solution had been running fine and has been deployed for about 2 months now.
All sensor pods are NBPD0155s. 2 of pods have 2 x spot fluids and a door sensor and the rest are only monitoring the room temperature and humidity. On the appliance itself we have 6 x dry contacts and are using both the leak rope ports.
Discuss challenges and get support in energy and automation with 30,000+ experts and peers.
Over 10,000+ support articles are available to help you find answers to your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!