This question was originally posted on DCIM Support by nanoman on 2018-10-25
Hi, can I configure the Netbotz 355 to send (via e-mail) a periodic report with only the temperature information and graph. Currently I received the report but it has information that is not required (is set up as OOT alarms).
Q2: I monitor for power failure use a ICM delayed restart relay and Botz dry contacts cable. Anyone have a simpler configuration / sensor ?
The ICM is powered by direct connection to wall outlet.
I use the ICM block because it will catch a under power or loss of power fast event
and can be programmed to stay in failed state for 1 to 10 minutes (I use 2 minutes
to ensure that Botz sees the event).
The botz and network are power via UPS.
Q3: on my 320 and 400 Botz I can use the status command (e.g. <botz ip
address>/status. This does not seem to work on my 355. Any thoughts?
Graphic of power fault monitor.
Discuss challenges and get support in energy and automation with 30,000+ experts and peers.
Over 10,000+ support articles are available to help you find answers to your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!