This question was originally posted on DCIM Support by Robert Quadrini on 2018-09-10
Is it possible to associate measured data with a DC Power Plant in DCO? Does predicted power work when using DC Power?
Solved! Go to Solution.
This answer was originally posted on DCIM Support by Jef Faridi on 2018-09-11
Would you mind to add more details about modeling "DC Power Plant" in DCO.
I had a quick look at the searched images from Internet, and wondering if the intention is to model them in DCO, then unfortunately that's not supported.
In DCO, currently DC power path/modeling is limited to Data Center and may not cover all DC devices/equipment.
But from the general point of view, if you have supported power path/model in DCO, then it should be possible to associate a DC device (from DCE) to it's model in DCO. The same goes for the Predicted Power/Estimated load strategy, it is general in DCO (for whole setup), eg. both for AC and DC power path.
This comment was originally posted on DCIM Support by Robert Quadrini on 2018-09-11
Thank you Jeff! I am not all that familiar with the DC power path at this point but the big concern was associating metered data with the modeled data which you answered.
Discuss challenges and get support in energy and automation with 30,000+ experts and peers.
Over 10,000+ support articles are available to help you find answers to your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!