Liebert ICOM DDF has decimal point in wrong place for temps

[DCIM_Support]

This question was originally posted on DCIM Support by Greg Conner on 2019-05-02

---

Hi, 

I'm trying to us the Liebert ICOM modbus DDF, and I've got it connected, but the several of the values seem to be off:

• The Condensor Outside Temp is showing 16.1 degrees F (it is 43 degrees out so I doubt this is correct)
• The Condensor Refrig Temps show 0 Degrees and 0.2 Degrees.. not sure if this is correct or not
• The Return Temp is off a decimal point (show 786.0 degrees and should be 78.6 degrees)
• The Temp Setpoint is off a decimal point (show 730.0 degrees and should be 73.0 degrees)
• Supply Temp sensor is missing
• Remote Temperature sensors are missing

(CID:143264910)

[DCIM_Support]

This answer was originally posted on DCIM Support by Jake Hiltz on 2019-05-03

---

Hi Greg,

Thank you for bringing this to our attention.  I have created ticket 14259 so someone can take a look at this.  You will be hearing back via that system.

Jake

(CID:143755172)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.