Is possible configure protocol SNMP in the server DCE from console?

[DCIM_Support]

This question was originally posted on DCIM Support by Leonardo Suarez on 2019-09-17

---

Good day

Is possible configure the protocol SNMP V3 in the DCE for the server, because for default the server active the agent SNMP (read and write community, port, contact and ubication) but not is possible select that kind of version and/or configure. 

From the console it is possible to configure something or not (SNMP v1, v3, etc).

Thanks…

(CID:148770623)

[DCIM_Support]

This answer was originally posted on DCIM Support by Steven Marchetti on 2019-09-17

---

Hi Leo,

Currently the DCE server only has SNMP version 1 capabilities. There is no option to monitor the system using SNMP version 3. Please also note that there are only a few server OS based values that can be monitored. No information about the DCE sub-system or any of the nodes being monitored can be obtained via SNMP.

Thank you,

Steve.

(CID:148770626)

[DCIM_Support]

This comment was originally posted on DCIM Support by Leonardo Suarez on 2019-09-18

---

Hi Steve,

Thanks for your reply. I needed to know if this possibility was possible.

(CID:151060615)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.