Is it possible to add outwards swing door?

[DCIM_Support]

This question was originally posted on DCIM Support by Bill Donnelly on 2018-07-05

---

HI, I'm building a number of rooms in DCO, tyhe Doors available in Room Fixture all swin inwards (into the room). 

All doors in my rooms swing outwards (out of the room).

Is there a way to either rotate the door, or select another door type, so that the door swings outside the room?

thnx

billd

(CID:132661101)

[DCIM_Support · Accepted solution]

This answer was originally posted on DCIM Support by Christopherus Laurentius on 2018-07-05

---

Hi Bill,

Drag the swing door from outside of the floor layout, and it should snap to the outer wall, to model door opening outward.

(CID:132661106)

[DCIM_Support]

This comment was originally posted on DCIM Support by Bill Donnelly on 2018-07-05

---

Thnx, that worked with a new door being added from the genome. It appears that once you add a door it keeps the same orientation with no way to change it. Need to delete it and add a new one again.

thnx again

billdfor the "top" wall, but I can't rotate the door (or flip where the door entrance is).

eg. I want to add the 'bottom' wall

(CID:132661116)

[DCIM_Support]

This comment was originally posted on DCIM Support by Christopherus Laurentius on 2018-07-05

---

Hi Bill,

You are right, on both counts.

The only way I can edit door placement is by deleting / re-adding it as well.

Could I trouble you to fill in a feature request to rotate door with your details?

Thanks!

(CID:132661126)

[DCIM_Support]

This comment was originally posted on DCIM Support by Bill Donnelly on 2018-07-09

---

Hi Chris, no probs,

thnx

for the help,

cul

billd

(CID:132662251)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.