Integratation Trend Control device to DCIM.

[DCIM_Support]

This question was originally posted on DCIM Support by Khalid on 2019-01-20

---

Hi Experts,

we are planning to integrate filed devices (mostly from Trend Control Systems) to DCE/DCO.

Please guide use how we can integrate these device to DCIM.

Regards,

(CID:138807288)

[DCIM_Support · Accepted solution]

This answer was originally posted on DCIM Support by spezialist on 2019-01-20

---

Dear Khalid,

To answer your question, you need more specific information (specify the model, type of equipment, etc.).

In any case, I suspect that we are talking about Trend controllers. In this case, there is a special Device Support resource on which you can check your equipment: is it supported by DCE and DCO software? If your equipment is not supported, you can make request device support for free.

With respect.

(CID:138807299)

[DCIM_Support]

This comment was originally posted on DCIM Support by Khalid on 2019-01-20

---

Hi,

I checked on Device Support and found many of them.

Thank you.

(CID:138809236)

[DCIM_Support]

This comment was originally posted on DCIM Support by spezialist on 2019-01-20

---

Ok, thanks for the good feedback 😀.

(CID:138809238)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.