How to get hardware information (Netbotz 250)

[DCIM_Support]

This question was originally posted on DCIM Support by Raphael FLAMENBAUM on 2019-11-13

---

Hello every one,

I am currently working with the Netbotz 250 Rack Monitor and I have to be able to get the following information regarding this equipment:

• Rack Monitor Identifier / Name
  Note: How do you configure the Rack Monitor name ?
• Rack Monitor Hardware Version
• Rack Monitor Serial Number

Until now, I have not been able to retrieve them via SNMP, syslog, ssh command.

I might, for sure, have done it wrong.

Therefore, would you know the different snmp OID or ssh commands to use to get such information?

I thank you in advance for the consideration you may pay to my request.

Best Regards,

rf2019

(CID:151065111)

[DCIM_Support · Accepted solution]

This answer was originally posted on DCIM Support by Cory McDonald on 2019-11-13

---

Hello Raphael,

Login via SSH and run the about command.  You will receive a list of results (you may need to scroll up to see them all).

There are results for: Model Number, Serial Number, and hardware revision within the HardWare factory section of the about command results.

Also, please ensure that your NetBotz 250 firmware is up-to-date.

Regards,

Cory

(CID:151065124)

[DCIM_Support]

This comment was originally posted on DCIM Support by Raphael FLAMENBAUM on 2019-11-14

---

Thank you so much.

It did work.

(CID:151584999)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.