This question was originally posted on DCIM Support by sheep on 2018-12-09
Hi
I want to find a specific connection inside an equipment (for example: Blade Center).
As you can see in the picture i uploaded, there are grey cables and blue cables.
The grey ones represent the other side of the panel (its ports are connected to other panel) and the blue ones represent multimode fiber cable.
I want to "catch" a specific blue cable and make changes in it, but in this example i can't do that because every place i click on, it gives me the grey cables and i can't get to the blue ones.
Is there any other way to do that except the visual way?
Thanks.
(CID:137109171)
Solved! Go to Solution.
This answer was originally posted on DCIM Support by Ed Tarento on 2018-12-10
Hi
Here's the whole blurb about cable management and specifically Configuring+network+connections+in+table+view might help
Cheers
Ed
(CID:137109480)
This answer was originally posted on DCIM Support by Ed Tarento on 2018-12-10
Hi
Here's the whole blurb about cable management and specifically Configuring+network+connections+in+table+view might help
Cheers
Ed
(CID:137109480)
This comment was originally posted on DCIM Support by sheep on 2018-12-10
Great, Thanks!
(CID:137109530)
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Discuss challenges in energy and automation with 30,000+ experts and peers.
Find answers in 10,000+ support articles to help solve your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!