This question was originally posted on DCIM Support by laurent dulac on 2019-06-11
We have a NetBotz 250 (Model : NBRK0250), that we received with the software 6.4.4.
By opening a SSH session and asking for the available commands (with : "?") we get the available System commands and the Device commands.
At some time we have been able to run the device commands "nbthsensor" and "nbinpsensor", to get the status of our sensors (temperature and doors sensors).
Since then we have updgraded the firmware to a newer version, but now, when we ask for the available Device commands ("?"), only the "modbus" command is available.
Why have the other commands disappeared ?
Do you know any mean to get them back ?
We have tried to install the original software (in our case 6.4.5 has been reinstalled), however we have no improvements concerning the device commands (they are still missing).
This answer was originally posted on DCIM Support by Balaraman Jagadeesan on 2019-06-12
I do not recommend to use an older version. The latest firmware version of NBRK0250 is 6.6.7. I can see all the device commands.
I hope this helps.
Discuss challenges and get support in energy and automation with 30,000+ experts and peers.
Over 10,000+ support articles are available to help you find answers to your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!