This question was originally posted on DCIM Support by Brian Meade on 2018-03-23
I have a question concerning DCO 8.2.2 and StruxureWare Portal 1.3.7. I have configured several portlets concerning power capacity and due to estimated load and the lack of measured data the power consumption is listed at 100%. However, I have measured PDU(s) and UPS systems.
This answer was originally posted on DCIM Support by Christopherus Laurentius on 2018-03-24
You may want to use 'Predicted Power' to get DCO Power capacity to use measured power whenever available, instead of estimated load.
To achieve predicted power to be as close as measured power, set the lower & upper threshold as 1.
See here to read more on Predicted Power
This comment was originally posted on DCIM Support by Waseem Khan on 2018-03-25
Jef Faridi I have somewhat same concern the power capacity is calculated based on the nameplate of the equipment's
Mobily has more than 10,000 equipment's in one data center, it is impossible to get the accurate values of each equipment and that is why the power capacity gets wrong
Please i need your support in this matter that how can we get the accurate power capacity as well as cooling capacity
PS: we have sensors on ups,pdu,rectifiers and on power panels but when we connected the power path and because of the wrong nameplate KW value on equipment's the power is exceeding on ups,pdu and power panel.
There is a huge difference between the sensor value and the actual value from nameplate
Discuss challenges in energy and automation with 30,000+ experts and peers.
Find answers in 10,000+ support articles to help solve your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!