EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-03 02:05 PM . Last Modified: 2 weeks ago
If you have to configure your network settings by hand,
during the installation process enter the “Network & Host Name” configuration:
Ethernet option “OFF”, and press the Configure button:
In the Ethernet connection settings, select the Device that contains MAC Address:
In the IPV4 Settings, enter IP address, netmask, gateway, dns, and then Save:
And now press the Ethernet button “ON”, and then Done:
That’s it.
(CID:114233340)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-03 02:05 PM . Last Modified: 2 weeks ago
Thanks for sharing 😀
(CID:114233627)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-03 02:05 PM . Last Modified: 2023-10-22 01:34 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.