Creating a wall under the raised floor

[DCIM_Support]

This question was originally posted on DCIM Support by sheep on 2019-01-13

---

Hi

We're trying to create a wall under the raised floor, as you can see at the picture below :

In this example we want to have a wall where the red X is located.

Is it actually possible?

Thanks.

(CID:137732025)

[DCIM_Support · Accepted solution]

This answer was originally posted on DCIM Support by Jef Faridi on 2019-01-14

---

Hi,

That's not supported - in general modeling equipment or wall under the raised floor is not supported/possible.

Kind regards

(CID:137732284)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.