Can we model parallel UPS in DCO 8X

[DCIM_Support]

This question was originally posted on DCIM Support by Russell Singh on 2019-06-27

---

I have a Colo Customer who has Parallel UPS units for each of 4 Datacenters, basically 2 400K Lieberts into a Parallel Board, one output from there to Distribution panel to multiple PDU's.

Each setup is done for and A and B side.

If I show as a single 800K unit, measured data is no longer correct.

Any ideas on how to model?

(CID:146277038)

[DCIM_Support]

This answer was originally posted on DCIM Support by Valentin Kozlov on 2019-06-28

---

HI Russel!

Parallel UPS units are not supported in DCO yet.

You may try to model it like Cris described in this topic:

(CID:146277214)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.