This question was originally posted on DCIM Support by Yaniv Rozenbaum on 2018-12-26
do you know where can i get the full mib for the ACRD602P
the mib in the Schneider Electric site is not full it is misse tie alarms !
This answer was originally posted on DCIM Support by Balaraman Jagadeesan on 2018-12-27
You can access ACRD602P Management Information Base details in the below link.
As mentioned in the document, ACRD602P uses Powernet MIB which can be downloaded in the below link.
I hope this helps.
This comment was originally posted on DCIM Support by Yaniv Rozenbaum on 2019-01-07
If you open the PDF you can see that
there is no Alarms OID
do you have the full Alarms OID for the unit ?
This comment was originally posted on DCIM Support by Balaraman Jagadeesan on 2019-01-08
Yaniv Rozenbaum Hi Yaniv, I hope you are doing well. The most recent Powernet MIB version is 4.2.8 that can be downloaded from
I also attached powernet428 file to this post here. powernet428.mib
If you have an access to the NMC card of this unit via SNMP, I suggest you to use any SNMP MIB browser such as iReasoning and try doing an SNMP walk and see if you are able to locate the SNMP OIDs for the alarms or status of the unit. I am sorry that I do not have an access to the unit online, and therefore I can not verify it. But, Powernet MIB is the one that ACRD602P Uses.
This comment was originally posted on DCIM Support by spezialist on 2019-01-05
Dear Yaniv Rozenbaum,
Please tell us if you could solve your question or not?
Discuss challenges and get support in energy and automation with 30,000+ experts and peers.
Over 10,000+ support articles are available to help you find answers to your product and business challenges.
Find peer based solutions to your questions. Provide answers for fellow community members!