Getting authentication failure when trying to set to password for "SystemReportsService" through "Building Operation WebReports Administrator"
1.6.0 RC and above
The Reports Agent can't check the password with the ES. This is dues to one of the three causes below:
 The Enterprise Server path is not correct
 The HTTP port entered for the reports agent is not correct
 The ES is not started
 The password entered is not correct
 The reports agent is not started
 The "Local System" account does not have high enough privileges to communicate out of the server
 Enter the right ES server path e.g. using "SBO Reports Agent Config"
 Enter the same port in HTTP in the ES Software Adminsitrator and the reports agent e.g. using "SBO Reports Agent Config"
 Start the ES
 Enter the correct password (you can change the defined password for the "SystemReportsService" through Workstation) Be sure to use the SystemReportsService account in the local domain of the ES
 Start the reports agent
 Change the report agent service to run under a local administrator account