Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
79539members
344371posts

CyberFort 350 (BF350-FR) overload problem

Solved
andreus_apc
Crewman
Crewman
0 Likes
2
135

CyberFort 350 (BF350-FR) overload problem

This was originally posted on APC forums on 9/14/2010


I recently found old CyberFort UPS in closet and wanted use it as UPS for my desktop. But "replace battery" LED lights with annoing sound.
So i found new battery for replacement, but UPS always do the same. But after holding power button for cca 2 sec. Replace battery LED turn off with sound. Power LED start blinking for a while. When Power LED stop blinking, and start light Overload LED start light too and again with annoing sound. I dont have any devices connected to UPS, so it cant be overloaded. What to do now?


Accepted Solutions
andreus_apc
Crewman
Crewman
0 Likes
0
135

CyberFort 350 (BF350-FR) overload problem

This was originally posted on APC forums on 9/14/2010


I recently found old CyberFort UPS in closet and wanted use it as UPS for my desktop. But "replace battery" LED lights with annoing sound.
So i found new battery for replacement, but UPS always do the same. But after holding power button for cca 2 sec. Replace battery LED turn off with sound. Power LED start blinking for a while. When Power LED stop blinking, and start light Overload LED start light too and again with annoing sound. I dont have any devices connected to UPS, so it cant be overloaded. What to do now?

See Answer In Context

2 Replies 2
BillP
Administrator Administrator
Administrator
0 Likes
0
135

Re: CyberFort 350 (BF350-FR) overload problem

This reply was originally posted by Jonathan on APC forums on 9/21/2010


Hi,

I see from your profile that you are from Slovakia. Our contact page shows that our Tech/Sales support can be contacted at 0800 17 20 63. Business hours is from 08:00-17:00.

andreus_apc
Crewman
Crewman
0 Likes
0
136

CyberFort 350 (BF350-FR) overload problem

This was originally posted on APC forums on 9/14/2010


I recently found old CyberFort UPS in closet and wanted use it as UPS for my desktop. But "replace battery" LED lights with annoing sound.
So i found new battery for replacement, but UPS always do the same. But after holding power button for cca 2 sec. Replace battery LED turn off with sound. Power LED start blinking for a while. When Power LED stop blinking, and start light Overload LED start light too and again with annoing sound. I dont have any devices connected to UPS, so it cant be overloaded. What to do now?