APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:30 AM . Last Modified: 2024-03-14 12:44 AM
Hi, My SUA1000i will not cold start properly - it tries to, then gives a continuous beep with a red overload light - but there is nothing at all attached to the UPS ! Running a self-test via Powerchute results in a pass.
Why is it doing this ? I need to to cold start for an oddball application (i.e. an extremely low power load (<10 watts) in a location that has no mains electricity). I can find no mention of the warning or the cold start procedure in the manual.
Any ideas ???
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:30 AM . Last Modified: 2024-03-14 12:44 AM
I have the same problem. After a 10 - 20 times to start without power.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-29 12:30 AM . Last Modified: 2024-03-14 12:44 AM
I have the same problem. After a 10 - 20 times to start without power.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.