Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
80564members
346445posts

How to reset Smart-UPS 1500 XLM to factory defaults

Solved
shawn_b_apc
Cadet
0 Likes
1
131

How to reset Smart-UPS 1500 XLM to factory defaults

This was originally posted on APC forums on 2/12/2014


Greetings,

I have several Smart-UPS 1500 XLM that are used to power my network equipment in the different buildings at my company. They work well.

I have these network and SNMP enabled and monitored by Solarwinds.

I need to reset one to it's factory settings as it appears the network settings have gone whack. The network card appears to be constantly rebooting.

Any assistance would be greatly appreciated.


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
133

Re: How to reset Smart-UPS 1500 XLM to factory defaults

This reply was originally posted by Angela on APC forums on 2/12/2014


Are you able to access the Network Management Card's interface momentarily at all? Also, I need to know the model of the pre-installed UPS Network Management Card - it is either AP9619 or AP9631. Depending on the model, you would follow a different set of instructions.

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
134

Re: How to reset Smart-UPS 1500 XLM to factory defaults

This reply was originally posted by Angela on APC forums on 2/12/2014


Are you able to access the Network Management Card's interface momentarily at all? Also, I need to know the model of the pre-installed UPS Network Management Card - it is either AP9619 or AP9631. Depending on the model, you would follow a different set of instructions.