Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
79290members
343968posts

AP8958 PDU LCD Rotation

Solved
BillP
Administrator Administrator
Administrator
0 Likes
1
109

AP8958 PDU LCD Rotation

This question was originally posted by Neal on APC forums on 5/20/2013


We have some PDU that we are powering via the subfloor. The PDU network Management module is upside down due to subfloor power.

I am aware of the keystroke to rotate the display.

But it appears that the module may be able to be unscrewed and rotated. Is this the case and if so is it APC supported? I don't want to void the warranty etc.

Thanks,

Neal


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
109

Re: AP8958 PDU LCD Rotation

This reply was originally posted by Angela on APC forums on 5/21/2013


It is only intended for you to rotate the display 180º by holding down the key combination. The display is intended to be field replaceable in case of fault or problem and requires a full power down of the PDU to replace so that is why you see screws. It is not intended to be rotated physically.

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
110

Re: AP8958 PDU LCD Rotation

This reply was originally posted by Angela on APC forums on 5/21/2013


It is only intended for you to rotate the display 180º by holding down the key combination. The display is intended to be field replaceable in case of fault or problem and requires a full power down of the PDU to replace so that is why you see screws. It is not intended to be rotated physically.